Hi people and merry christmas. Im looking for any design or ideas to making a lamp. Any help welcome. Thanks.
Hi people and merry christmas. Im looking for any design or ideas to making a lamp. Any help welcome. Thanks.
You can try making something like this which is not too hard. Good luck
Last edited by Sergio Arze; 12-15-2009 at 7:24 AM.
Machinaria M350 laser engraver
CorelDRAW X3
CorelDRAW 12
PhotoGrav3
There are a few free plans here, they are all laser cut from thin wood or tyvek
http://www.ponoko.com/showroom/category?query=Lighting
This is an interesting company, they don't have a US distributor yet, click on the design link then lighting:
http://www.microwood.com/
I make these:
yourpersonalizedspace.com
The art work is all copyrighted, but I could give out the basic box design, they are cut from 1/8 baltic birch.
Best regards
Gary
Last edited by Mike Null; 12-15-2009 at 6:44 AM. Reason: removed link
Hi
Here is the blank lamp cutting diagram in both illustrator and eps formats, I need to re install corel, so I can't post a .cdr file
I've also sent a couple of pics of finished lamps.
It takes a cord like this one:
http://www.nationalartcraft.com/images/sub-0016-03.jpg
from here:
http://www.nationalartcraft.com/subc...&cid=1&scid=16
Best regards
Gary
Epilog Mini 18/25w & 35w, Mac and Vaio, Corel x3, typical art toys, airbrush... I'm a Laserhead, my husband is a Neanderthal - go figure
Red Coin Mah Jong