Originally Posted by
Rich Bygness
I have read that a lot of you don't think that keeping the fence square with the table, or t-track, or anything else is at all important. My concern is when I am using a relatively large Freud bit to make baseboard trim, I need to take of just a little bit at a time. I have the Kreg PRS 1040 Precision router table system including the micro adjuster. The problem I have is that even with the left side knob loosened, if I move the right side of the fence 1/16" back, the left side does not move an equal distance unless I put a square to it to make it square with the table, so I am not actually taking an extra 1/16" off the workpiece. Will the Incra, Jessem or other fence move the entire fence equally the same distance? I am also wondering which fence would be most adaptable to the Kreg router table. Thanks for any helpful recommendations.