Page 2 of 2 FirstFirst 12
Results 16 to 20 of 20

Thread: Wood Corer

  1. 02-25-2010, 7:31 AM #16
    Ray Bell
    Ray Bell is offline [OP] Member
    Join Date
    Feb 2003
    Location
    Richland Wa.
    Posts
    784
    Again, thanks all. There are some great reviews, and sound advise in this thread. I will have to think on this a bit.

    Ray
    Reply With Quote Reply With Quote
  2. 02-25-2010, 7:54 AM #17
    Sandy Smith
    Sandy Smith is offline Member
    Join Date
    Sep 2009
    Location
    NJ outside Philadelphia
    Posts
    12
    I have owned the oneway corer. I never had a problem with it and the cost was great. I am done with that type of turning now and only do small opening turning now..... see the classified for my corer forsale.
    Reply With Quote Reply With Quote
  3. 02-25-2010, 1:27 PM #18
    Alec Moseley
    Alec Moseley is offline Member
    Join Date
    Aug 2008
    Location
    Mobile, Alabama
    Posts
    39
    I had the Woodcut system and liked it, but check the size limitations (max. 16" swing I think). When I got my new lathe it became unusable.
    Reply With Quote Reply With Quote
  4. 02-26-2010, 11:54 AM #19
    Skip Spaulding
    Skip Spaulding is offline Member
    Join Date
    Nov 2006
    Location
    Vermont
    Posts
    589
    McNaughton system has worked great for me.
    Reply With Quote Reply With Quote
  5. 02-26-2010, 11:56 AM #20
    Dick Strauss
    Dick Strauss is offline Member
    Join Date
    Aug 2005
    Location
    Midwest
    Posts
    2,043
    Ray,
    I had success with the Oneway 9.5" corer the first time I tried it. I managed to core 3 bowls out of an 8" blank and I didn't make any funnels.

    YMMV

    Take care,
    Dick
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules