I'm looking for information on the piece that goes into the lower trunion. I've gotten my guides and I go to install the lower guide and it is 1/16 of an inch to the left of center, needless to say the bearings are not lining up correctly. The peice that came with my lower guide is straight and offset to raise the guides off the frame so if I try to turn it into a different position the guides hit the frame and will not go in. What I want to know is if anyone on here has gotten a set of carter guides for this bandsaw and did they have this issue and how did you correct it? Or do you have a different bar that your guides are attached to the trunnion with?