Shop: It' getting there

[Jon Lanier]

Was able to work in the 'new' shop a bit today. It's amazing when you have to take apart tools, move 11 hours away, and then not be able to get to them for 3-4 months.... how many 'parts' go missing.

-I finally was able to put the lathe up on it's bench and now running.
-Bandsaw put back together and on it's stand, now working
-Hawk Scroll saw, put back together with all missing parts found now working.
-Air Hose/Reel all hung from ceiling.

Need to get done:

-Table Saw (got a new Link Belt on but that's about it)
-Drill Press needs work and then mounted on stand.
-New Work bench need to be made
-Peg Boards on walls.
-All the rest of shop lights.

Hoping to have most of it done by the end of Saturday.

[Greg Woloshyn]

Nice, your much further along than I am. I still have to replace my garage floor because its cracked and sinking! Worst part is, I have a brand new Delta table saw in my living room that Im dying to use.

[Mark Stutz]

Was able to work in the 'new' shop a bit today. It's amazing when you have to take apart tools, move 11 hours away, and then not be able to get to them for 3-4 months.... how many 'parts' go missing.

.

3-4 months is barely time to blink! I'm at 18 and counting! Hopefully wood will be sacrificed soon

Mark

[Jon Lanier]

We have a church clean up day tomorrow and was told to bring my chain saw. That thing hasn't run for almost a year. I cleaned it up, sharpened some chains. And had a 30 minute work out... but it finally started.