I have just installed a cyclone collector in my shop and am using 6" plastic
sewer pipe exhausted outside. I have a piece of 6" flex pipe going into the shop through the wall. My problem is that i am having a hard time finding
6" sewer pipe to run in the shop. My question is can i use 4" pipe from the
6" pipe to run in my shop. Will it cause too much loss of suction and make
the motor run hot? I have a2hp motor and blower mounted on the cyclone.
By the way the cyclone is outside the shop. The 6" sewer pipe is rather
costly and i am looking for an alternative. Byron