Hi,
I've been searching for box making software that was listed here some time back that could use millimetres as well as inches called BoxMaker (?).
I can't remember if it was a macro for Corel or a stand alone programe.
I've come across a couple- Rahulbotics (Can't get it to run on W7) and Box Making VBA Macro. Called FingerBox.gms (only has inches as far as I can see).
The software I had downloaded here (before the hard disk crashed) allowed the conversion to mm by changing the dialog box (rather than a calculation to the 3rd decimal point)
I've searched on Box Maker software, Box Maker macro, BoxMaker etc.
If anyone can point me in the right direction I would be very thankful
Thanks
Dave