Ok, finished turning this one and wiped it down with water for the pics.
It is alot deeper then my first, 6"x 3.25"
I had alot more trouble with my current tools and ofcourse lack of expierence. The Bowl gouge worked well, however i think i need to order a few other tools that might make my life easier and would like your opinion on a basic set of tools for bowls would consist of. Brand and size would be most helpful. I hate buying the same tool 3 times when I could have bought one that works first.
I did have trouble at the convergence of the side to bottom mainly because I could not seem to get a clean cut and as I was trying to clean it all up I ended up taking more material away then I wanted (I am sure alot of that will come with more turning) The bottom got a bit thin on me, plenty left but not enough to make corrections so I will apply this to #3 and hopefully get it right.
Comments, suggestions and advice very much welcome!