Never mind - it's a right hand thread.
I can't get the helical gear off the end of the cutter head. It's such a tiny hex I'm afraid to over do it. Might it be a left hand screw - looks likely do to the head drive direction.
Thanks
Never mind - it's a right hand thread.
I can't get the helical gear off the end of the cutter head. It's such a tiny hex I'm afraid to over do it. Might it be a left hand screw - looks likely do to the head drive direction.
Thanks
Last edited by Mike Goetzke; 10-26-2010 at 9:38 PM.