Hello Gang,
I would like to cut some dowel rods in half for a project. How can this be done? Using a V-Block? How do I clamp the dowel in the V-Block to keep it from turning? Thanks for the help
Joe
Hello Gang,
I would like to cut some dowel rods in half for a project. How can this be done? Using a V-Block? How do I clamp the dowel in the V-Block to keep it from turning? Thanks for the help
Joe
what size?
If they are sufficiently large so kerf loss is not a major consideration I suppose a pair of V-blocks held together with screws or dabs of glue would hold them firmly enough to run through the table or bandsaw.
Or... Maybe a bit of glue on each end of the dowel in a v-block would work so you could run the dowel through the planer. That does double your dowel wastage.
Just guessing.
Drill a hole in 2 blocks of wood to fit the dowel and glue onto each end. Cut with table saw and then cut off blocks.
No PHD, but I have a DD 214
vblock, hot glue is the easiest. If you don't have a hot glue gun you can try some 100 grit sandpaper on the vblock. Handsaw works best for me.
Make a square block for the front and rear of the dowel, make the square equal in dimension to the rods diameter, attach using dowel pins and glue, then cut the dowel rods in half, bandsaw would be my preference though TS would work, and then cut off the half squares from each end. You could also clamp them to a v block, use a dado or regular blade and a cross cut sled or miter gauge to create a flat at each end, say 1/4" deep, then glue a piece of 1/4" MDF or such to this to establish a foot, cut these off after splitting the dowels,
Maybe I'm missing something here, but wouldn't it be easier to take flat stock, make two passes on a router table with the appropiate round over bit, then cut off the semi circle on the table saw?
Jim: Bingo!
I'm with Jim
CW Miller
Whispering Wood Creations
I am fond of pigs. Dogs look up to us. Cats look down on us. Pigs treat us as equals.
Winston Churchill
Joe, I ran into this same problem a while back, and here is what I did and it worked great.
I took the dowel and edge glued it to a piece of pine or plywood scrap same length as the
dowel . After the glue had dried for a while, I ran the piece through the band saw with the flat edge against the rip fence set at the proper distance to cut the dowel in half length wise, I popped the glued half off the scrap board it was glued to....and I was done.
Everyone is assuming he wants to rip it.
I would pin it to some flat stock with a 23ga pinner and rip in in half on the bandsaw.. Right through the pins..
You also need to keep in mind that most dowel rods - at least the ones I've come across are rarely straight. So factor that into whatever you plan to do.
Where did I put that tape measure...
First sight down the dowel as if aiming gun. Now rotate 180 degrees and sight down the other end. Find an empty corner in the shop or, more likely, the house. Place the floor end of the dowel about 3" from each wall forming the corner. Lean the upper end back until it gently touches the adjoining wall surfaces allowing the dowel to stand in this position. Now, go find your car keys and drive to the hardware store and buy some half-round.
Seriously, if you want to match a material and I imagine you do. Acquire a router bit with the proper roundover, mill a piece of your material 3" or more wide to the proper thickness and make two runs on the router table to get a half-round profile. Saw off the strip and you have your trim. This removes the problems you would face with the removal of the saw kerf leaving you with an "almost half" round if you were to saw a dowel in half.