Did a couple of Peppermills using a CA glue finish

[Jerry Beevers]

To do a CA finish on a large project as a peppermill, do you use a slower setting ca or do smaller sections? Thanks.

[Marty Tippin]

To do a CA finish on a large project as a peppermill, do you use a slower setting ca or do smaller sections? Thanks.

I'd use a super-thin CA and apply many coats with a shot of accelerant in between. Thick CA will just make a mess. Here's a good video by Cap'n Eddie where he puts a CA finish on a hollow form, much larger than a pepper mill. https://www.youtube.com/watch?v=VRXSkmTJ4Pw

[Steve Schlumpf]

Jerry, I highly recommend starting a new thread on CA finishes. This thread is almost 10 years old and the original poster and many of the players in the thread are no longer active.

[Bill Bulloch]

Wonder why I am not seeing pictures of the Mills. Did you delete them?

[Jim Becker]

Bill, the OP posted this 10 years ago per Steve's mention just before yours. The photos were hosted off-site and it's likely that account is no longer active judging by the site graphic that does show.

Jim
SMC Moderator