To do a CA finish on a large project as a peppermill, do you use a slower setting ca or do smaller sections? Thanks.
To do a CA finish on a large project as a peppermill, do you use a slower setting ca or do smaller sections? Thanks.
I'd use a super-thin CA and apply many coats with a shot of accelerant in between. Thick CA will just make a mess. Here's a good video by Cap'n Eddie where he puts a CA finish on a hollow form, much larger than a pepper mill. https://www.youtube.com/watch?v=VRXSkmTJ4Pw
Jerry, I highly recommend starting a new thread on CA finishes. This thread is almost 10 years old and the original poster and many of the players in the thread are no longer active.
Steve
“You never know what you got til it's gone!”
Please don’t let that happen!
Become a financial Contributor today!
Wonder why I am not seeing pictures of the Mills. Did you delete them?
Bill, the OP posted this 10 years ago per Steve's mention just before yours. The photos were hosted off-site and it's likely that account is no longer active judging by the site graphic that does show.
Jim
SMC Moderator