Hi
I'm a new turner, and need some advice. I have a BB 5/8 bowl gouge and a DT 5/8 V gouge. Both have the same grinds. Because of something I'm doing wrong the BB cuts better then the DT.
I'm using the Wolverine sharpening jig. I have a ~45 degree fingernail profile. I started with the recommended grind on the DT, but changed it to eliminate that as a possible reason for the difference in cuts.
I'm not flaming the DT and know the DT is a much better gouge, but I can't figure out what I''m doing wrong.
Thanks in advance for any help.