Help needed with carving text.
I have not been using my router at all the last few months. The last time I did use it I crashed it into too much oak to fast. I did shut it shut it down fast. However I had to changes the brushes on the PC 7518.
This month I have been cutting some temples out of plywood without issues. Recently I was asked to carve some text into a board for a hope chest. The photos tell the story for the most part.
My problem exists no matter what type of text I use some fonts have more errors than others.
The problem did not show up in the plaque that you see with text that starts with “As for me and my house”
Any text I did on other projects before this plaque was off as you can see in the pictures; any text after this plaque is wrong as you can see in the pictures. This plaque is fine.
3D work comes out fine.
Do you think this is a file issue? I used aspire to create the tool path files.
Grounding Issue?
Corrupt ini file issue?
I bent something when I crashed the machine?
Other?
Right now I am at a loss.
Sorry for the long post.
https://picasaweb.google.com/jrj5x5/...Lys5TwpYz4pgE# I tried the new photo upload system here, and by time I shrunk the photos small enough to them to fit (107kb), you could not tell what you what you were looking at.
Jim J.