Hey everyone,

Please mind the newbie sharpening question...

I have lots of experience hand sharpening my flat blades (planes, bench chisels, etc) but I know nothing about sharpening curved and round edges. It seems like everyone uses a grinder which makes sense. I have been researching and the most common reccomendation is a slow speed 8" bench grinder with something like a Wolverine jig. I came across the following grinder at busy bee here and it seems like it might be a good option, but I am unsure if it is too low speed to be effective for gouges etc. It has a small 5" wheel that spins 3450rpm, but it also has a 10"x2" large wheel in a water bath that turns only 72rpm!

Is this going to be appropriate?

http://www.busybeetools.com/products...D-GRINDER.html