Results 1 to 9 of 9

Thread: table saw add-on for cutting sheet goods

Threaded View

Previous Post Previous Post   Next Post Next Post
  1. 04-29-2011, 1:42 PM #1
    scott vroom's Avatar
    scott vroom
    scott vroom is offline [OP] Contributor
    Join Date
    Sep 2009
    Location
    Three Rivers, Central Oregon
    Posts
    2,340

    table saw add-on for cutting sheet goods

    I have a G0690 table saw and am looking for an after-market rig that I can attach to my saw that will allow me to make accurate cuts/dados across long/narrow sheet goods. I'm building 96" tall cabinets, typically with 12-15" deep sides...so the stock will be 12-15" wide and 96" long. I need to be able to crosscut accurate dados and rabbets. I'm currently doing this with a hand held router and a straight edge, which works but setup time is unacceptable for production work. I need a rig that will hold the stock square to the blade and support the long end with a telescopic feature. Does it exist?

    Darn, should have bought a slider in the first place!

    thanks
    Last edited by scott vroom; 04-29-2011 at 2:09 PM.
    Scott Vroom

    I started with absolutely nothing. Now, thanks to years of hard work, careful planning, and perseverance, I find I still have most of it left.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules