Results 1 to 2 of 2

Thread: Antique Oil Problem?

  1. #1
    Join Date
    Jul 2007
    Location
    Central Indiana
    Posts
    955

    Antique Oil Problem?

    I just finished a piece that has maple and oak burl in it. I was using antique oil on it. I have used it in the past for my turnings and have really liked the finish I ended up with.

    This time however, I have a problem. I put on the third coat two days ago. The finish on the maple is dry with no problem but on the oak burl the AO did not seem to dry. It is still tacky to the touch.

    What would cause this problem?

    Will it eventually dry?

    If not, what do I do about it?

    TIA

    Toney

  2. #2
    Join Date
    Jul 2008
    Location
    Tomball, TX (30 miles NNW Houston)
    Posts
    2,747
    Oak and oak burls have large pores.

    AO (assuming Minwax brand) is nothing more than an oil/varnish blend. A poly varnish, linseed oil and mineral spirits.

    Keep wiping it until it's dry then give it a few days. Remember ol/varnish blends are in-the-wood finishes. They are too soft to build a durable film finish.
    Scott

    Finishing is an 'Art & a Science'. Actually, it is a process. You must understand the properties and tendencies of the finish you are using. You must know the proper steps and techniques, then you must execute them properly.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •