Results 1 to 15 of 46

Thread: Hall table

Threaded View

Previous Post Previous Post   Next Post Next Post
  1. #38
    Alan,
    Attached is a couple of closeup views showing the drawer front and leg relationship as well as the dovetails for the drawers. Note the edge of the drawer face does not come to a point. In fact the outside edge is actually square to the face at that point.

    Drawer runners will be mortised into the front legs and a couple of vertical members at the back.

    Curved rails will be laminated. It's up to Bart to decide on method. We've discussed two. Either multiple thin layers or a thicker outer piece with saw kerfs and an inner one to stablize the bend and hide the kerfs.

    Drawer fronts will probably be the second method but again it's up to the craftsman.

    I suppose cockbeads could be done. It doesn't seem to be the thing Bart or Fran want.

    Doors may be coopered although bagging would be good, too.

    As to SketchUp, it shouldn't take you very long to get the hang of it. Certainly not six hours a day. Just give it a few minutes here and there. You'll get it.
    Attached Images Attached Images

Similar Threads

  1. Table Saw Overarm Guard/Dust Collector Mounting
    By Mike Scoggins in forum General Woodworking and Power Tools
    Replies: 20
    Last Post: 01-12-2008, 12:16 AM
  2. New design project: Hall table
    By Zahid Naqvi in forum Design Forum
    Replies: 4
    Last Post: 12-28-2004, 12:48 AM
  3. Out Feed Roller Table Review
    By Ted Shrader in forum General Woodworking and Power Tools
    Replies: 11
    Last Post: 12-07-2004, 2:13 PM
  4. Router Table Quest
    By Maurice Ungaro in forum General Woodworking and Power Tools
    Replies: 15
    Last Post: 09-17-2004, 12:23 PM
  5. Hall Table Design
    By Brian Triplett in forum Design Forum
    Replies: 2
    Last Post: 02-19-2004, 5:10 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •