Results 1 to 6 of 6

Thread: Barbed Kerf Hinge - Kerf hinge Blades

  1. #1
    Join Date
    Nov 2006
    Location
    Middle Georgia
    Posts
    47

    Barbed Kerf Hinge - Kerf hinge Blades

    I'd like to try using barbed kerf hinges in a few of my small boxes. However, Rockler's price for the kerf hinge blade is off the chart. ($44 for the kerf hinge blade and another $44 for the arbor).

    I know I can find the arbor for a much more reasonable cost.

    But, is there a less expensive solution for the kerf hinge blade?

    I know this topic has been discussed before, but I can't seem to find an answer to that $44 blade. Your advice is appreciated.
    Last edited by Al Stramiello; 06-22-2011 at 7:41 AM.

  2. #2
    I bought them at Grizzly at a much lower price

  3. #3
    Join Date
    Jun 2009
    Location
    Long Island N.Y.
    Posts
    483
    Woodcraft sells the same blade and arbor for $23 and $26 respectively.
    Rockler has the lowest price on the hinges though, at $.99. Woodcraft asks $2.50 for the hinges.

  4. #4
    Join Date
    Nov 2006
    Location
    Trussville, AL
    Posts
    3,584
    Those look similar to the hinges Lamello sells that you cut kerfs for with a biscuit joiner...

  5. #5

  6. #6
    Join Date
    Nov 2006
    Location
    Middle Georgia
    Posts
    47
    Great information . . . exactly what I was looking for.

    I knew Grizzly had cheaper arbors but I wasn't certain which slitting saw to order.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •