Johnny, there are 2 bolts that go down through the caster blocks and screw into T-nuts that are imbedded in the bottom of the frame. Lifts the floor pads about 1/2" off the floor. Rolls easily. Note the hole between the 2 casters on the second picture? That is for a threaded rod to go through to screw down to lift that end of the base off the ground to make it easier to put the casters on. There is one at each end. But I've found it easier/faster to use a pry bar and some wood blocks under the base while screwing the casters on. Actually the only time I've done it is when I put the saw in place. Haven't needed to move it since. Hope I don't have to. Here's a picture with the storage cabinet in place. DSCN2683.jpg Jim.
Last edited by Jim O'Dell; 07-03-2011 at 5:48 PM.
Coolmeadow Setters...Exclusively Irish! When Irish Eyes are smiling....They're usually up to something!!
Home of Irish Setter Rescue of North Texas.
No, I'm not an electrician. Any information I share is purely what I would do myself. If in doubt, hire an electrician!
Member of the G0691 fan club!
At a minimum, I'm Pentatoxic...Most likely I'm a Pentaholic. There seems to be no known cure. Pentatonix, winners of The Sing Off, s3.