I have searched high and low to find some plans for a Shaker Cradle similar to the following:
http://www.flickr.com/photos/plasticmind/tags/cradle/
or:
http://www.finewoodworking.com/item/...-cherry-cradle
I can probably almost build it without a plan, but I am fretting over the angle of the sides. Some I have seen have the same splay on all sides, other have more on the top (head) and then the sides and bottom are the same angle.
I almost think it would look cool to make the head angled a bit more....but not sure!
I have seen angles of 11 degrees all around down to 6 degrees.
I am also undecided on the height of the sides. I do want to start with a base of 15x33 to fit a standard crib pad, but not sure on the side height.
Thanks for any direction!
Dan