In my ULS driver, when I go to - settings, manual , under the raster tab, the print special effects drop down is grayed out, it won't let me select clip art, 3d etc. Anyone know what's going on with that?
driver.jpg
[OP]
Member
In my ULS driver, when I go to - settings, manual , under the raster tab, the print special effects drop down is grayed out, it won't let me select clip art, 3d etc. Anyone know what's going on with that?
driver.jpg
Member
Try clicking on "Frame Raster" first.
Trotec Speedy 300 - 60w, with Quatro CSA-626 fume extraction
Xenetech 1625 x2,
New Hermes TX pantograph, CG4 cutter grinder
Brady Globalmark2 label printer,
Assortment of custom tooling , shears & punches, heat bender.
Software: Xenetech XOT, Corel X3, Bartender label software
Contributor
Gary,
Do not choose the material from the materials data base, go directly into the Manual tab and you should be able to change it from there. This is caused because of the material you chose from the database. Some of the pre set settings will not allow you to change certain things.
Print, Properties, Manual settings you should get all 8 colors and have complete control over everything.
One other thing if you are going from the UCP Settings then you will not be able to change certain things that have already been printed.
Last edited by Mike Mackenzie; 10-14-2011 at 4:42 PM. Reason: adding
Mike Mackenzie
Sales and Service of Universal Laser Systems
Member
Mike,
Would this new driver work with my old V-400 system?
I am still running 107M driver, I believe.
Trotec Speedy 300 - 60w, with Quatro CSA-626 fume extraction
Xenetech 1625 x2,
New Hermes TX pantograph, CG4 cutter grinder
Brady Globalmark2 label printer,
Assortment of custom tooling , shears & punches, heat bender.
Software: Xenetech XOT, Corel X3, Bartender label software
Contributor
Tony,
No, The systems use completly different electronics.
Mike Mackenzie
Sales and Service of Universal Laser Systems
Member
Thanks Mike,
That is what I thought.
Trotec Speedy 300 - 60w, with Quatro CSA-626 fume extraction
Xenetech 1625 x2,
New Hermes TX pantograph, CG4 cutter grinder
Brady Globalmark2 label printer,
Assortment of custom tooling , shears & punches, heat bender.
Software: Xenetech XOT, Corel X3, Bartender label software
[OP]
Member
In my case, I have a design computer in the network, and a xp box that runs the laser somewhere else on the network as in the attached diagram.
I talked to Jeff at ULS support, and finally got everything configured correctly, so I can print to the laser from the design system, bring up the ULS driver and set the options, and send the job to the xp box where it's in the queue for the printer with the correct settings.
Jeff didn't think that was a common setup, so if anyone else need to do that, I can document it.
Gary
setup.jpg
Posting Permissions
Reply With Quote