So I picked up a 2-1/4 Triton off Ebay. The auction said barely used and it doesn't really show any signs of too much wear. However it seems to have a lot of vibration. When I have it mounted in my table it is almost unbearable. If you touch the top of the table it almost hurts from the vibration. I have tried both the 1/4" and 1/2" collet with bits. Both seem to have the same problem. Measuring the run-out of a 1/2" straight bit it was off by about .004". If I take the collet out and measure the run out ait is about .003. Did the former owner wear out the bearings or are they shot?

I talked to the seller on Ebay and he has offered to work something out. Maybe I should go with the 3-1/4 HP Woodcraft has on sale.