We found the time today to use our ShopBot to make a desk for the laptop computer we use to run the CNC ShopBot router.
The first picture is Aaron sitting at our temporary table running the ShopBot files that are cutting the new desk. The desk is cut from one sheet of plywood and has finger joints that allow it to be disassembled and reassembled as necessary. There are wedges that are driven into the joints to tighten them.
The second picture is the desk after rough assembly to check the fit. The long pieces sticking out are the wedges which we slipped into the joints, they won't be driven in tight untill the desk is stained, edge routed and then final assembly.
Total routing time start to finish was 45 minutes.
I'll post another picture of our shop computer desk as soon as it is completed.