Results 1 to 4 of 4

Thread: Easycut vs Lasercut

  1. 03-06-2012, 4:20 PM #1
    Vicki Rivrud
    Vicki Rivrud is offline [OP] Friend of the Creek
    Join Date
    Nov 2008
    Location
    Sunny Palm Harbor Florida
    Posts
    223

    Question Easycut vs Lasercut

    Does anyone know is the Chinese controller software Easycut a version of Lasercut - relabeled?

    Is it being used with any other controller other than the Leetro controllers (6515/6535 etc?)


    Thank,
    Vicki Rivrud
    JR Laser Solutions
    Reply With Quote Reply With Quote
  3. 03-07-2012, 3:51 AM #2
    John Thomson
    John Thomson is offline Member
    Join Date
    May 2007
    Posts
    18
    Hi Vicki,

    my Redsail runs from Easycut 5.3, this is simply Lasercut rebadged by Redsail........

    John
    Reply With Quote Reply With Quote
  4. 03-07-2012, 9:55 AM #3
    Vicki Rivrud
    Vicki Rivrud is offline [OP] Friend of the Creek
    Join Date
    Nov 2008
    Location
    Sunny Palm Harbor Florida
    Posts
    223

    Easycut vs Lasercut

    Thanks for the reply . . . which controller comes with your Redsail?
    Reply With Quote Reply With Quote
  5. 03-07-2012, 1:32 PM #4
    John Thomson
    John Thomson is offline Member
    Join Date
    May 2007
    Posts
    18
    Hi,as far as I am aware it is the 6515 controller.john
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules