I would like some ideas on using 7 12'x15"x2" spalted maple planks. These are still rough sawn without the bark on the edges.
I'm not sure about the legs mostly and should I use the maple or find some nice log legs(Not a problem). She also would like bench seats and again I have the leg questions.
The maple is around 15%(would like at least 10%) now but I'm afraid if I resaw the boards the center may still be higher. I like the idea of 2" or 1 1/2" table top with rough edges.
I could cut up a couple boards and make legs is the other idea.
The area will be covered but a strong weather finish will be required.
Has anyone seen pictures I could look at to get an idea.
Thanks