I'm trying out shellac for the first time. I used a 2 lb cut of dewaxed shellac. I was sloppy on my first coat and I got some dark spots where it ran from the inside of the wood to the outside. I let it dry, sanded it a little bit with some 400 grit paper, then put another coat on. I had hoped that the little sanding would help and then it would dissolve into the second coat, but it didn't. Is there a trick to getting rid of these spots? Do I have to sand it down to the wood again and re-do it, or can I do something to help dissolve it away?
I attached a picture to show what I'm talking about. (hopefully it worked)
Thanks,
Eric