is it possible that his saw blade crank will move the blade from one detent to the next detent, I hope that detent is the correct word for a index
is it possible that his saw blade crank will move the blade from one detent to the next detent, I hope that detent is the correct word for a index
This method was an article in American Woodworker. Just as in making cove cuts on a table saw, my guess is that you can only raise the blade about 1/16 - 1/8 in. at a time as you are cutting with the side of the teeth. Also, even with a very good blade, sanding will take some effort.
Jerry
"It is better to fail in originality than succeed in imitation" - Herman Melville
Roger, why not go get a lathe? Because he spent $4000 on his SS tablesaw and doesn't have any more money for other equipment!
I drink, therefore I am.
You could really hurt yourself much faster with a dado blade on the saw!!
Should say, "Professional driver on closed course, DO NOT ATTEMPT!"
robo hippy
If he's using a Saw Stop saw, there shouldn't be any concern about him getting hurt. Isn't that why that particular saw was invented?? Stick a weenie in it, and it doesn't hurt the weenie but instead trashes the saw... Now, we just need to get a lathe that will lock up just before a turned item decides to explode. Wouldn't that be something???? No more trips to the doc's office, just down time repairing the lathe..... Jerry (in Tucson)
can't believe that the SS safety feature would be of any use with the blade contacting wood prior to your fingers which it would have to with that setup
safety all to one side , why would you want to spend the effort to sand that nightmare after the fact? i too will stick to the lathe for bowl making