Bump, update and new issue

LN is a world class company and they will make sure your issue is addressed.

In addition to my issue with the LN chipbreaker, which had no work around, I encountered another issue, this time on a 5-1/4 with a PMV11 iron and veritas chipbreaker to match, the problem this time was not about the blade not protruding, perhaps partially due to a more generous setting of the chipbreaker back from the edge, however the head of the screw which holds the blade-chipbreaker combo was hitting the bottom edge of the cavity (the cavity in all frogs specifically for housing the cap iron screw) in the frog. This had a simple solution, I ground the head of that screw to a slightly smaller diameter, the knurling is gone, but that is a minor inconvenience.

/p