Clint,
I noticed your DC connection is on the top of your sanding table. Do you have any form of internals to draw the dust towards the DC inlet, or does it work OK without?
Jim
Clint,
I noticed your DC connection is on the top of your sanding table. Do you have any form of internals to draw the dust towards the DC inlet, or does it work OK without?
Jim
One can never have too many planes and chisels... or so I'm learning!!
Thanks Jim,
The wings help a lot. I can also cut compound miters. Each wing is held on with one rear earth magnet. It is very to move the wing aside. With the wings removed, I still get very good dust collection.
Sam
I have two pictures of the one I made in my Picasa album: https://picasaweb.google.com/113966569709555812037/DC