[OP]
Member
Hi,
I have an interesting question. Whats the best way to remove dried General Finishes Seal-A-Cell wipe on poly from glass. Normally I would use a straight razor and just scrape it off. However on this glass there is a UV coating on the glass, so I am not sure I just want to start scraping. Any ideas?
Thanks,
Mark
Contributor
A UV coating like a film on the inside of car windows or some kind of chemical UV treatment?
If the latter I would try a small area; if it's the film I would not even try...
Scott
Finishing is an 'Art & a Science'. Actually, it is a process. You must understand the properties and tendencies of the finish you are using. You must know the proper steps and techniques, then you must execute them properly.
Posting Permissions
Reply With Quote