Greetings to all!
I have an Epilog EXT using Corel X4.
I have an issue where if I draw a 2x2 square and put the center of that square at x:1, y:1, the engraver only cuts the right and bottom lines. Epilog is telling me it should cut all 4 but the top and left lines would be the very edge of the table.
I'm starting to think there is a discrepancy between Corel and the engraver or the engraver does not know where the edge of the table is.
Any ideas?
EDIT: I figured I should share some info.
To set the page up, I go to Tools, Options, Document, Page, Size, Select the Legend Engraver fromt he list, click "Get Page Size From Printer" and make sure the width and height are correct (32.0, 24.0) and Bleed is 0. I Click OK.
The engraver is set up with the following home positions:
X Home: -0368
Y Home: +0141
X R Home: +0303
Y R Home: -0602
Laser Match: -02
Stamp Match: +00
Encoder Match X: +01
Encoder Match Y: +41
Laser T.M.: +00
Laser T.I.: +00