A while ago I ran across a post here at SC that was a cdr file of kitchen measurements. ie-teaspoon, tablespoon, cup, pint, etc.
I have searched and searched and cannot locate it again. Can someone please direct me to the file?
Many thanks!
A while ago I ran across a post here at SC that was a cdr file of kitchen measurements. ie-teaspoon, tablespoon, cup, pint, etc.
I have searched and searched and cannot locate it again. Can someone please direct me to the file?
Many thanks!
Epilog 45 watt, Graphtec cutter-plotter, Corel Graphics Suite X3 - X4, HP and Vaio computers, woodshop.
"Trust, but Verify"
Found the file on my fourth search!
Epilog 45 watt, Graphtec cutter-plotter, Corel Graphics Suite X3 - X4, HP and Vaio computers, woodshop.
"Trust, but Verify"
So where did you find it? - it sounds useful.
Thanks
you can always find your files using search on start win button and just write .cdr or any other extension and will search for all files with that ext. on your comp.
Shenhui laser 60W, corel Draw X5.
Where did you find it Don ? I was unable to locate it here.
LaserPro Sprit 30 Watt...Corel X5..PhotoGrav 3.0
The thread is dated 2-7-2011. Titled Laser engraved mini cutting board.
However, when I try to open the attached Cdr. file it opens a blank page???
Do not know why it is not working correctly?
Epilog 45 watt, Graphtec cutter-plotter, Corel Graphics Suite X3 - X4, HP and Vaio computers, woodshop.
"Trust, but Verify"
maybe you are using a older version of CD. here it is in ver. 10
EPILOG LEGEND 32 60 WATT, CORELDRAWX5, PhotoGraV2.11, strip heater, PUNTA GORDA, FLORIDA