A simple question - how do I clean off the gunk on a new chuck?
Thanks
A simple question - how do I clean off the gunk on a new chuck?
Thanks
A good wipe down with mineral spirits is a good start. On a new chuck after the initial wipe down I soak it good with mineral spirits, mount it on the lathe and put a cardboard box over and turn it on at full speed. Throws a bunch more gunk off and all over the inside of the box.
I've always used a bucket of mineral spirits and just swish the chuck around then oper jaws all the way and swish it again. Let set for a few minutes then do the box trick Bill B said about. An old paint brush comes in handy.
Comments and Constructive Criticism Welcome
Haste in every craft or business brings failures. Herodotus,450 B.C.
WD-40 worked good to clean mine.