new bit design cuts faster less passes

[stan kern]

I tried a new bit design as advertused to cut faster but clean and not hard on the router .It worked fine its a spiral but different end and reverses,the cut is clean sawdust removal was great
will try another cut tommorow using a 1/2 variety this time

100%

http://youtu.be/cbUZg89Hqkg
100%

[Mike Heidrick]

Their site is not great. What bit did you get and where did you get it?

[stan kern]

you're right there site is difficult to nose around ,

fhorvath@fstoolcorp.com this is franks email for info
the bit was rst2058m-ud2 1/4 and rst2061w-ud2 1/2

FS Tool Corporation
71 Hobbs Gate
Markham, ON Canada
L3R 9T9
http://www.fstoolcorp.com/Company/Contact.aspx

email frank and he will show you were to look