Hi gang, I am looking for a small lever type punch press for punching holes in SS, most of what I use is 20ga material. I have looked at Di-Arco punches and they run about $900-$2500. I really only need to punch some mounting holes from time to time on tags and whatnot. Normally I have my steel vendor do it, but run into an occasion when a cutomer wants a one off tag or two and it's a pain getting my vendor to do these. Does anyone know of a small (inexpensive) press for doing this. What do you use? I've seen the one Marco sells but not sure if it would handle the 20ga stuff. I know this probably should go into a different forum, but was hoping some of the laser people have done this.
Thank for looking.