Working on a Dinette table. Edges needed a bevel on them. Got out a couple planesSDC14272.jpg and bevel the ends first. Planes are a #1203, and a #18. After both ends were where I wanted them, I switched it around so i could do the longer front and back edgesSDC14273.jpg I used a #6 for this work. Cleaned it up with the #18. I also tried out a Union #5A as a smoother. SDC14274.jpgI HATE knots! Table is getting almost done, set the top on the base, just for a glimpse at what it might look like.SDC14275.jpg So far, all i have bought for this table project is a single bottle of glue Might gave it a few coats of BLO