Well, I went and did it! I ordered a CRP4848 from CNCrouterparts.com. I also ordered a Hitachi M12VC from Amazon to go with it. The sad things is, I already own a M12VC but I dropped it one time with a 3 1/2" long 1/2" flush cut bit in it and of course, the router hit on the bit on an angle. Ever since, that router has not run true so I assume I slightly bent the armature.
Anyway, here is what all I ordered in case you are interested!
1 x CRP4848 4' x 4' CNC Router Kit
- Version: Nema 23 Compatible (Standard)
- x Pro Rack and Pinion upgrade
1 x VCarve Pro CAM Software
1 x Mach3 CNC Control Software
1 x Complete Cable Track Kit
- Machine Size: CRP4848 4' x 4'
1 x 4 Axis Electronics Kit
- Cable Upgrade: (2) 12' and (2) 20' cables
- Motor Shaft Diameter: 3/8" (Low Inductance 320 oz-in
1 x Hitachi M1VC Router Mount
- Version: Standard
1 x Emergency Stop
1 x 10 Foot Parallel Port Cable
1 x Proximity Limit Switch Kit
Now to start on my base and wait for the parts to get here! Then I have to figure out how to use the darn thing! Does anyone have any links to good, general CNC Router operation tutorials?
I'll try to keep you guys posted on my progress! I am not going to do a build log as I want to just get it done and not worry about taking pictures! I may take a few and will certainly take some when complete.
Thanks for all your advice and help in my other thread! Now I just have to get over the shock of spending over $5k on shop equipment! This is the second largest woodworking purchase I have made for tools. My Timberking 1220 was the largest but not by a whole lot!