I'm starting on a window seat for our house that will double as toy storage for the kids in our playroom. Pretty sure I have a handle on everything except for the lids. I'm playing to mount them with piano hinges and struts for safety. My original design had a bullnose edge what was mitered on the inside corners and the lids were set 4" inside the corners. This made access to the back of the side cabinets a little impractical as it was over 20" deep from the lid opening to the back wall. I then laid out the top with almost fill width lids, but am having an issue on how to layout the inside corners where the lids meet. I switched to a 3/4 x 1.5" edge on this version with a 3/8" round-over for simplicity in sketchup. The actual edge will probably be different but similar in dimensions. What's the best way to go about this and have nice cleans lines for the lids to open? It's designed to go in as 3 separate pieces so I can build the cabinets in my garage.
Window Bench.jpgWindow Bench Edging.jpg