I'm making the Rockler Pony Rocker (really U bild plan 738). I'm getting ready to make the leg wedges. That must be to splay the legs out at the correct angle.

Can you help me find an better way to do this than the instructions? It calls for cutting wedges, 7 inches long, 1 1/8 at the large end and 1/4 at the small end. I'm to cut 18 of these wedges, using some on each leg, gluing them up and fitting behind the large end of the leg, and then cut them to match the round part of the leg.

There must be an easier or more efficient way. I prefer the bandsaw to the tablesaw if it all possible. Thank you for your help, Ellie