Results 1 to 7 of 7

Thread: Router Table in progress (pics)

Threaded View

Previous Post Previous Post   Next Post Next Post
  1. #1
    Join Date
    Jan 2005
    Location
    USA
    Posts
    2,271

    Router Table in progress (pics)

    Just to let SMC know that I do a little working between asking so many questions, I thought I would share a couple of pictures of a router table I am in the middle of finishing. I know I promised Tim some shots a few days ago in another post.

    I am open to any suggestions or constructive critisim before I get any further along and can adjust. Hardware is not on the doors yet and still many last minute details to acomplish. The left door will be temporary as I hope to add drawers in it's place later on. I may cut re-cut the right door so the upper RH door will cover the hole next to the switch.

    Constructed mostly from 3/4 oak ply with Rockler Table top and extension wings. Dust collector port/chute not in place yet, but it's coming Plan on finishing in Golden Oak stain (upper doors are example) with many coats of wipe on poly.

    LOML says not to add center trim to upper doors, what do you folks say?

    I Know I am a newbie so please go easy on any mistakes you see
    Attached Images Attached Images
    Last edited by Bob Noles; 06-05-2005 at 4:06 PM.

Similar Threads

  1. Advice needed on new Tool purchase
    By Tom Hurlebaus in forum General Woodworking and Power Tools
    Replies: 32
    Last Post: 05-02-2008, 4:21 AM
  2. Table Saw Router Table (pics) (long)
    By Tim Palmer in forum General Woodworking and Power Tools
    Replies: 3
    Last Post: 01-25-2005, 7:00 AM
  3. Router Table Quest
    By Maurice Ungaro in forum General Woodworking and Power Tools
    Replies: 15
    Last Post: 09-17-2004, 12:23 PM
  4. Cherry Lumber GLOAT...and Router Table Progress
    By Andy Haney in forum General Woodworking and Power Tools
    Replies: 2
    Last Post: 07-20-2004, 12:48 PM
  5. Router Table Base Progress pics
    By John Lach in forum General Woodworking and Power Tools
    Replies: 4
    Last Post: 07-14-2004, 12:49 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •