My new Hammer slider was delivered last week, and I have it set up and powered, now I need some technique. I did cut a few pieces to glue up for solid wood end panels, and it is very cool to just cut a board and find it ready to glue up a panel, but getting the edges parallel would be nice. Does a book exist that would help you get the most out of your sliding table saw? By the way, I bought a 12" Tenryu rip blade, and the pieces just zinged through the saw. Very smooth. I think I am going to enjoy the saw very much, just have no experience with sliders. Used a table saw in junior high school, but this thing is very different.