So I have completed step 1 of going to a table sawless workshop (sold my saw). Now its time to buy a bandsaw. I have decided that given my budget I am going to try and get the best 14" I can. I think I am going to go used as I have basically $400 to spend. I was tempted because Grizzly is only about an hour or so from me, but for the saw plus gas and tax, I would be upwards of $600 unless I went with there most basic saw which is 3/4hp and single speed.
I have a couple of options around me right now and wanted to pass them by you all.
http://baltimore.craigslist.org/tls/4363908092.html
http://harrisburg.craigslist.org/tls/4383868740.html
http://baltimore.craigslist.org/tls/4365868233.html
The first one is definitely an older saw. Not sure if that is better or worse. The Ridgid is only 10 minutes from me. The guy said he would go $250 but was pretty firm. I have ready mix reviews on these saws. The craftsman looks heavier than the one they make now and it says its 1.5hp. He has the miter gauge but no fence. Says he will do $400 but is firm. I am about an hour from Baltimore so I so want to drive that far without be prepared to pay.
Are any of these worth looking at for the asking prices or should I just be patient and sit tight?