I don't know what I am doing but here is an attempt at showing my clock. I am not sure this is where it belongs so any input will be appreciated. I started the clock when I wanted to learn how to operate the 4th Axis on my router table. I just finished building the 4th axis and didn't have a clue how to work it. I laminated a bunch of Mahogany and built a large dia. cylinder, see first video. That didn't turn out to be a challenge so I decided to put numbers around it, that was a little tougher, Video 2 but I was not sure what to do with it. I had thought about a clock and was not sure how. I played with it a while and rigged up a lever system to turn it 12th of a turn. I put it away after that and started thinking about how to make it do something.

clock pic1.jpg
If you want to see video 2 I will need to figure that out too.

If I want to add to this thread I'll need to figure that out. I'll try the next step later. Thanks Jerry