Tips for engraving on both sides of a substrate?

[Andrew Holloway]

Did you notice that the pieces are about 1/4" and he is talking about a 12x24 piece of material? On a piece that is 11x23 that would be 1024 pieces - the time to cut and flip the pieces would be more than offset by wasting 1/2" of material.

And when you have 1024 pieces, the kerf width is going to add up quite quickly and you will end up with most of them not aligned.

[Keith Upton]

And when you have 1024 pieces, the kerf width is going to add up quite quickly and you will end up with most of them not aligned.

So long as I push the "inner sheet" back up tight against the upper left of the opening, I don't think kerf will be an issue then... the cut coming last and all??