Let’s get right to the point…what am I doing wrong?
I just rehabbed a moving fillister plane and was practicingwith it and I am only getting the desired results on the majority of therabbet. I start planning at the far endand begin planing with the grain until I reach the near end and the stopbottoms out. This works great for allbut the last eight inches or so that need to be planed. There is a decided upward curve on the nearend that I cannot get to go away. Theplane is just skating over this area and then planes the rest of the board asexpected – so I feel it has to be my technique.
Any thoughts, comments and suggested solutions to try willbe greatly appreciated.
Thanks in advance,
lcombs