Good day Everyone!
Having only cut smaller more intricate designs with my laser, I was unaware that it is currently cutting/lasing out of square. Measuring corner to corner over the entire size of the table(26x20) it is 1/8" out of square. Laser is an Pinnacle Accuris model 30watt.
I have moved the machine a couple of times, but have always been careful to secure not only the laser engraver, but the gantry inside as well. All of the linear slides have the original silicone "Unbroken" marking points on the screws, telling me that they have not been previously adjusted.
So my main question is, could this be any type of a software issue, or is this wholeheartedly a nuts and bolts problem? Any ideas before I start adjusting manually? Thanks for your help! Marc