I'm having a little bit of trouble with leveling up the side wings on a older Powermatic 72 table saw.
There's three 1/2" dia. bolts per wing & I can get the top/wings pretty much totally flat by just loosely snugging everything up, But once I firmly tighten everything up one or two of the corners want to lift-up or pull-down slightly.
I got the saw & wings from different sources, So there's always a chance that one or the other is not truly square with each other?
I was just wondering if there's any tips or tricks to leveling up the side wings?
It's not off by much, Probably less than 0.015 but it's enough to notice.
Doug