Good afternoon all,
I am working on new kitchen cabinets for my mom and I wanted some opinions on the best way to put these doors together (design is hers). I have made a prototype (see picture). My prototype door was made using tongue and groove for the vertical pieces as well as the horizontal ones. Everything got glued. This door has stayed together and flat in my basement for the past 2 years, so I'm not opposed to making the rest of them the same way. I do, however, think that you all would probably have a better way of doing this.
I should add that I was thinking about breadboard ends. Or perhaps some sort of modified frame and panel?
photo1.jpg
Sorry the photo is turned sideways. Not sure how that happened.
Thanks,
Ryan