I currently have a 12" sliding compound miter saw which is working fine but i'm a bit put off by the footprint it requires. It uses a 42" deep by 46" wide area. I have to angle it off to one side when i'm done so I don't keep knocking into the table angle adjusting arm when I walk by. it's 38" deep when angled out of the way.
I'm wondering if anyone out there has a 10" or 12" RAS and could tell me what the footprint is that it uses. If it's comparable, then I might try and pick one up on craigslist as a replacement for my mitersaw.
Thanks for any input you can provide.
Mike